Water Damage Drywall Repair in Gainesville, FL
Water damage drywall repair means finding the leak, cutting out wet board, drying the cavity, and putting in new board. Wet drywall that stays wet for more than 24 to 48 hours can grow mold, according to the EPA. A wet 4 by 8 section cut out and replaced ran $820 on one of our past jobs.
Free estimate. Send a few photos with the form, or call and we will talk it through.
📞 Talk to a Drywall Expert: (352) 649-3354Request a FREE Quote
Water Damage Drywall Repair, explained in plain English
We start with a moisture meter. A stain on the outside can hide a larger wet area inside, so we check the board around it. We open only what is wet. If the cavity is still damp, it needs to dry before new board goes in, which can take a day or two with fans.
New board goes in tight, usually mold-resistant board in bathrooms and laundry rooms. We tape, coat and match the texture. Then we prime with stain-blocking primer so the repair does not bleed through later.
What to think about before you start
- Fix the leak first. New drywall under a dripping pipe fails again.
- Wet insulation needs replacement too.
- Musty smells mean moisture behind the wall. Do not paint over it.
- Insurance claims often want photos and a written scope. We can supply both.
What it costs around Gainesville
The published water damage section range is about $350 to $1,200, depending on size and finish. A wet 4 by 8 section ran $820 flat. Mold-resistant board costs more per sheet than standard board. We confirm the price after seeing it in person.
Planning ranges from our local rate card, not a quote. See the cost guide and calculator.
How it goes in Gainesville
Gainesville gets more than its share of water damage: summer storms, air conditioner drain overflows, slab leaks and slow plumbing drips in humid bathrooms. After a hurricane season storm, we get calls for roof leaks that stained ceilings.
How the job goes, step by step
- Find the source and confirm the leak is fixed.
- Meter the area and mark the wet board.
- Cut out and remove wet board.
- Dry the cavity and replace insulation if needed.
- Hang, tape and match texture, then stain-block and prime.
Quick answers about water damage drywall repair
How long does drywall take to dry after water damage?
The wall cavity can take a day or two with fans. Drywall that has been wet for more than 24 to 48 hours often needs to be replaced.
Can wet drywall be saved?
Sometimes, if it was wet briefly and is clean water. Soaked, soft or moldy board should be replaced.
How much does water damage drywall repair cost?
Roughly $350 to $1,200 for a section, depending on size and finish. A wet 4 by 8 section ran $820.
Will insurance cover it?
That depends on the cause and your policy. We provide photos and a written scope for your claim.
Do you test for mold?
We look for visible mold and tell you what we see. Testing is a separate service done by a licensed mold assessor.
Why use mold-resistant board in a bathroom?
It has a treated face that resists moisture better than standard board. See moisture and mold-resistant drywall installation.
More questions? See the full FAQ.
Ready for a straight answer on your drywall?
Call or send photos. We will tell you what we see and what it should cost, and we confirm the price in person before any work starts.
📞 Call (352) 649-3354 Request a free estimateGet a free water damage drywall repair estimate
Tell us about the job. Photos help us price it before we visit.